System Setup
3-86 System view Versana Balance – Basic Service Manual
5808768-100 English Rev.9
3-9-4 Setup connection to a DICOM server
Versana Balance is configured to work with DICOM servers in a
network environment. Images are first saved on the local image
butter on the system. At the end of the examination the images
are sent to the DICOM server via a DICOM spooler and to the
local database, depending on dataflows.
To connect to the DICOM server, the following information has to
be entered in the system.
• The DICOM server IP address
• The DICOM server port number
• The DICOM server AE title (the server application's name)
Table 3-28: Utility ->Connectivity ->TCP/IP screen
1 Enter the Versana Balance computer name. This may be the same as the station name.
2 Enter the Versana Balance IP address, subnet mask, default gateway and network speed.
For automatic assignment of IP address, subnet mask and default gateway, select
DHCP.
Note: If possible, set the Versana Balance network Speed to match that of the Network switch. if in
doubt, set it to AutoDetect. Otherwise, transfer times can be two or five times longer, during which
the Versana Balance will appear to be locked up. (If the Hard Drive activity light on the front of the
console is lit steady or blinks quickly, the Versana Balance is most likely not hung.)
To Next Page
Loading...
