GE HEALTHCAREDRAFT VOLUSON® P8 / VOLUSON® P6
DIRECTION 5459672-100, R
EVISION 6 DRAFT (JANUARY 17, 2013) PROPRIETARY SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-7
Figure 8-6 Activate Software
10.)After UISApp is running, check the installed version by following these steps:
A.) Press F2 (Utility) hard key on the console
B.) Select "System Setup", and select "Administration".
C.) Select "System Info" tab.
D.) Check the version tag from the System Info Software panel as shown in the example
figure below.
Figure 8-7 Version Info
E.) The software version tag should read like: 13.0.0 and Level should be Extn: 1 A.
Select A
To Next Page
Loading...
