ADP200 Application PID-IMM User Manual Pag. 2 of 80
Add. New Draws and Modif (FW1_0_0).
Upd new FW and flow/ pres tuning V1_18_37_1
Upd Last fw FW1_0_1 App V1_x_37_1
Pag 2: mod. Sw. version; add pars 11080 and 11082 on
menu 5.3 REFERENCEs; renamed par 11066 to Press
Ramp Acc Coef and 11068 to Speed Ramp Acc Coef.
Removed TORQUEFF_TUNING and
Brugali
Ch. 5.8, add “GUIDELINES about how to use the
GAIN_SCH menu”. Mod Auto Setup description on Menu
Update chapter 4 Commissioning via GF_eXpress
Pag 35 corrected pars name ANALOG INPUTS menu;
pag.55 mod text chapter 5.7 SWITCH_GAIN Menu
Add GF_eXpress block diagrams
Variuos minor corrections
PROTECTIONS MENU: new pars 11048 and 11050
Gain Scheduling menu: new pars 11080, 11082, 11084,
11086, 11088, 11090, 11092, 11094, 11096, 11098,
12160, 12162,
Modified Gain schedule and Control block diagrams.
Correct IPAs on SET column (table on “Variable gain”
section) and 5.8.1 Gain Scheduling Parameter List.
This manual applies to the hardware and software configurations of the following drives:
ADP200 Version V4_0_0
PID-IMM Application V 2.22.37.0
------------------------------------------------------------------------------------------------------------------------------
Thank you for choosing this Gefran product.
If you have any information that might help us to improve this manual, do not hesitate to contact us at
tecnohelp@gefran.com
.
Before using the product, read the safety instructions section carefully.
Keep the manual in a safe place and available to technical personnel during the product functioning period.
Gefran Drives and Motion Control S.r.l. reserves the right to modify products, data and dimensions without
notice.
The data indicated are provided for the sole purpose of describing the product and must not be considered
as legally binding characteristics.
All rights reserved.
To Next Page
Loading...
Need help?
General