ADP200 Application PID-IMM User Manual Pag. 42 of 80
General settings
554 Access Mode
550 Save Par
582 Drive Reset
Monitor application signals
12008 Pressure Fbk
12012 Pressure Ref
12006 Speed Fbk
12010 Speed Ref
12004 Torque
Pressure references
11054 Manual Press Ref
11056 Manual Speed Ref
11062 Pressure Ref Source
11064 Flow Ref Source
11010 Pump Direction
Control
11086 Kp Pressure Control
11088 Ki Pressure Control
11094 Kp Speed Control
11096 Ki Speed Control
666 Speed Ref filter (*)
1510 Analog inp 1 filter (*)
Monitor overload
368 Drive Overload (*)
3212 Motor Overload (*)
Save and enable management
1012 Dig local/remote (*)
1016 Terminal Start src (*)
1018 Digital Enable src (*)
1020 Digital Start src (*)
1410 Dig output 1X src
1430 Dig out 1X inversion
596 Save Par To SD
598 Load Par From SD
(*) parameters visible on Expert mode only.
To Next Page
Loading...
