gefran ADV200 WA DC Series

ADV200 WA • Quick start up guide - Specification and installation 3
Table of contents
Information about this manual ................................................. 2
1 - Safety Precautions ............................................................... 6
1.1 Symbols used in the manual ............................................................................6
1.2 Safety precaution ..............................................................................................7
1.3 General warnings .............................................................................................7
1.4 Instruction for compliance with UL Mark (UL requirements), U.S. and Canadian
electrical codes .......................................................................................................9
2 - Introduction to the product ................................................ 11
2.1 Drive type designation ....................................................................................12
2.1.1 Parallel inverters ..............................................................................................................13
3 - Transport and storage ........................................................ 14
3.1 General ...........................................................................................................14
3.2 Permissible Environmental Conditions ...........................................................15
4 - Mechanical installation ...................................................... 16
4.1 Inclination and mounting clearance ................................................................16
4.2 Fastening positions .........................................................................................17
5 - Wiring Procedure ................................................................ 22
5.1 Power section .................................................................................................25
5.1.1 Cable Cross Section ........................................................................................................25
5.1.2 Connection of shielding ...................................................................................................27
5.1.3 EMC guide line ................................................................................................................28
5.1.4 Block diagram power section ...........................................................................................29
5.1.5 Internal EMC lter ............................................................................................................31
5.1.6 Power line connection ......................................................................................................32
5.1.7 Input mains choke (L1) ....................................................................................................35
5.1.8 Motor connection .............................................................................................................36
5.1.9 Braking unit connection (optional) ...................................................................................37
5.1.10 Parallel connection on the AC (Input) and DC (Intermediate Circuit) side of several
inverters ....................................................................................................................................38
5.1.11 Parallel DC connection...................................................................................................39
5.1.12 Connection of fans .........................................................................................................40
5.2 Regulation section ..........................................................................................42
5.2.1 Removing the terminal cover ...........................................................................................42
5.2.2 Cable Cross Section ........................................................................................................42
5.2.3 Regulation section connection .........................................................................................42
5.2.4 Switches, jumpers and LED .............................................................................................44
5.2.5 Power supply unit regulation card (only for sizes ≥ 72000) .............................................47
5.3 Braking ...........................................................................................................49
5.3.1 Braking unit ......................................................................................................................49
5.4 Serial interface (XS connector) .......................................................................51
5.4.1 Drive / RS 485 Port (not insulated) point-to-point connection ..........................................51
5.4.2 Drive / RS485 port point-to-point connection (with insulation) .........................................52
5.4.3 RS 485 multi-drop connection .........................................................................................53
5.5 Typical connection diagrams ..........................................................................54
6 - Use of the keypad ............................................................... 58
6.1 Description ......................................................................................................58
6.2 Navigation .......................................................................................................59
6.2.1 Scanning of the rst and second level menus .................................................................59
6.2.2 Display of a parameter .....................................................................................................59
6.2.3 Scanning of the parameters ............................................................................................60
6.2.4 List of the last parameters modied .................................................................................60
6.2.5 “Goto parameter” function ................................................................................................60
6.3 Parameter modication ...................................................................................61