gefran AFE200 Series

AFE200 • Instruction Manual 113
Menu PAR Description UM Type FB BIT Def Min Max Acc
14.2.4 4010 Fieldbus M->S enable ENUM Enable 0 1 ERWZ
Setting of eldbus data updating.
0 Disable
1 Enable
If set to 0, the possibility of sending commands and references from the drive PLC via
the eldbus is disabled.
If set to 1 the possibility of sending commands and references from the drive PLC via
the eldbus is enabled.
Menu PAR Description UM Type FB BIT Def Min Max Acc
14.2.5 4012 Fieldbus alarm mode INT32 0 0 1 ERWZ
Setting of the Opt Bus Fault alarm generation mode.
0 Off
1 On
If set to 0 the alarm is only generated if the drive is enabled.
If set to 1 the alarm is generated even with the drive disabled.
Menu PAR Description UM Type FB BIT Def Min Max Acc
14.2.6 4014 Fieldbus state ENUM Stop 0 7 R
The logic status of the eldbus connection is displayed. The value depends on the
type of bus that is used.
These logic states are displayed if the selected eldbus is CANopen:
0 Stop
1 PreOperational
2 Operational
These logic states are displayed if the selected eldbus is Probus:
3 Error
4 WaitPRM
5 WaitCFG
6 DataExchange
7 DPError
14.3 - COMMUNICATION/FIELDBUS M2S
Menu PAR Description UM Type FB BIT Def Min Max Acc
14.3.1 4020 Fieldbus M->S1 ipa FBM2SIPA 0 0 0 R
14.3.5 4030 Fieldbus M->S2 ipa FBM2SIPA 0 0 0 R
14.3.9 4040 Fieldbus M->S3 ipa FBM2SIPA 0 0 0 R
14.3.13 4050 Fieldbus M->S4 ipa FBM2SIPA 0 0 0 R
14.3.17 4060 Fieldbus M->S5 ipa FBM2SIPA 0 0 0 R
14.3.21 4070 Fieldbus M->S6 ipa FBM2SIPA 0 0 0 R
14.3.25 4080 Fieldbus M->S7 ipa FBM2SIPA 0 0 0 R