CHAPTER 6
OPERATION
General Information
(Fig. 6-1)
CAUTION
BEFORE starting the engine and operating the
loader, review and comply with ALL safety
recommendations in the SAFETY chapter of
this manual. Know how to STOP the loader
BEFORE starting it. Also, BE SURE to fasten
and properly adjust the seat belt and lower the
operator restraint bar.
Before Starting Engine
Before starting the engine and running the loader, refer
to the Controls & Safety Equipment chapter and
familiarize yourself with the various operating controls,
indicators and safety devices on the loader.
Starting The Loader
WARNING
ALWAYS fasten your seat belt and lower the
restraint bar BEFORE starting the engine.
The following procedure is recommended for starting
the loader engine:
1. Carefully step up onto the back of the bucket or
attachment while grasping the ROPS handles to get
into the operator’s compartment.
2. Fasten the seat belt and lower the restraint bar.
3. Verify the following:
q
the lift/tilt and drive control handles are in
their neutral positions
q the auxiliary control is in neutral
q
the brake is on
q
the high flow control lever (DX models only)
is in neutral
4. Push the throttle forward to half of full speed.
NOTE: When the key is turned to the “ON”
position, a buzzer will sound momentarily
reminding you to check that your seat belt is
fastened.
5. Turn the keyswitch to the “ON” position. Wait for
the glow indicator light to go out, then turn the key to
the start position. (Glow is automatically controlled
and is used only if temperature is 32°F (0°C) or
below).
NOTE: Crank the starter until the engine is started.
If the engine fails to start within 15 seconds, return
the key to the “Off” position and repeat Step 5.
Cranking the engine for longer than 15 seconds
will result in premature failure of the starter.
After the engine starts, allow a sufficient warm-up time
before attempting to operate the controls.
PRINTED IN USA 37 907808/CP0300
Fig. 6-1: Operator’s Compartment
1. Operator’s Seat
2. Operator Restraint Bar in “Lowered” Position
3. Seat Belt
2
1
3
To Next Page
Loading...
