Gema MagicControl 4.0 - Load Coating Programs; Creating Coating Programs; Copy and Insert Coating Programs

Rev. 00 08/17
44

Operation MagicControl 4.0 (CM40)
Load coating programs
1. Press the symbol
Fig.
28
2. Select coating program
3. Press the key
– The selected program is loaded
Creating coating programs
If the error message “Program not available” is displayed when copying
or loading coating programs, this means that no coating programs have
been created and that the program must be created again.
1. Copy any existing program, preferably a related similar one, so that
you do not have to make many changes
2. Insert
3. Load
4. Edit coating programs
Copy and insert coating programs
1. Select coating program