Gema MagicControl 4.0 Operating Instructions

Rev. 00 08/17
MagicControl 4.0 (CM40) Spare parts list

79
Spare parts list
Ordering spare parts
When ordering spare parts for powder coating equipment, please indicate
the following specifications:
– Type and serial number of your powder coating equipment
– Order number, quantity and description of each spare part
Example:
– Type OptiGun GA03 automatic powder gun
Serial number 1234 5678
– Order no. 203 386, 1 piece, Clamp – Ø 18/15 mm
When ordering cable or hose material, the required length must also be
given. The spare part numbers of this bulk stock is always marked with
an *.
Wearing parts are always marked with a #.
All dimensions of plastic hoses are specified with the external and internal
diameter:
Example:
Ø 8/6 mm, 8 mm outside diameter (o/d) / 6 mm inside diameter (i/d)
ATTENTION
Use of non-original Gema spare parts
When using the spare parts from other manufacturers the
explosion protection is no longer guaranteed. If any damage is
caused by this use all guarantee claims become invalid!
► Only original Gema spare parts should be used!

Gema MagicControl 4.0 Specifications

General

Brand	Gema
Model	MagicControl 4.0
Category	Control Unit
Language	English