Gema MagicControl 4.0 - Naming Coating Programs; Search Coating Programs

Rev. 00 08/17
46

Operation MagicControl 4.0 (CM40)
Naming coating programs
1. Touch the desired table entry.
– The line is highlighted.
Only lines which are highlighted can be changed, clicking on
another line only moves the selection.
2. Touch the highlighted line again.
– A keyboard opens to name the coating program.
Fig.
33
: Naming coating programs
3. Enter object name
4. Press the RET key to confirm
Search coating programs
Search by name
1. Press the search field (7)
– A keyboard opens to search for coating programs by
alphanumeric entry.
Fig.
34
: