Gema MagicControl 4.0 Operating Instructions

Rev. 00 08/17
MagicControl 4.0 (CM40) Operation

47
– Only coating programs that match the search are listed.
Pay attention to upper and lower case as well as spaces!
Search by numbers
1. Press the number field (8)
– A keyboard opens to search for coating programs by numerical
input.
– The number searched for is displayed at the top of the list.
User administration
Status display
The log-in status is displayed in the corresponding bar:
User logged in
User logged out
Login
The user can log in in two ways:
– When starting the plant (See chapter "Starting the plant" on page
29.)
– By clicking on the symbol in the log-in status bar , if another user
has previously logged off
Fig.
35
: Login
Log in by user selection
Log in by entering user name
Enter user password

Gema MagicControl 4.0 Specifications

General

Brand	Gema
Model	MagicControl 4.0
Category	Control Unit
Language	English