Gema OptiStar CG08-C User Manual

V 02/18
42 • Initial start-up OptiStar CG08(-C)
6. All values are reset. The control unit must be set-up again.
Shutdown
1. Release gun trigger
2. Switch off the control unit
NOTE:
The adjustments for high voltage, powder output volume and
electrode rinsing air remain stored
If in disuse for several days
1. Separate from power mains
2. Clean the coating equipment (see the corresponding
operating manual)
3. Turn off the compressed air main supply

Gema OptiStar CG08-C Specifications

General

Brand	Gema
Model	OptiStar CG08-C
Category	Control Unit
Language	English