Gema OptiStar CG08-C User Manual

V 02/18
38 • Initial start-up OptiStar CG08(-C)
- if no operation is started within 15 s (not in Remote operation
mode)
- if the cleaning sequence has finished
The active cleaning function is terminated immediately when exiting this
mode.
The cleaning mode is terminated by pressing the
key.
Monitoring of wearing parts and trigger counter
1. Press key 2x
The display switches to the following level: The display
switches to the following level:
2. Press
and at same time
Monitoring is activated
During the first activation a value of 1 is shown as the start
value. If monitoring has already been activated at some
earlier point, then the last stored value is displayed.
3. Set the desired service life for each wearing part using the
or
4. The reverse counter is then activated and runs only during
active coating
5. If the selected service life is exceeded, the service symbol
appears on the display. The coating procedure is not affected
by this.
Trigger counter
The trigger counter (total time in days of trigger time) is shown in the
display A5.
The trigger counter can't be reset!
A5

Gema OptiStar CG08-C Specifications

General

Brand	Gema
Model	OptiStar CG08-C
Category	Control Unit
Language	English