14
INSTALLING THE DUST OUTLET AND CONNECTING THE INTERNAL HOSE (CONTINUED)
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS UN-
PLUGGED. DO NOT PLUG IN OR TURN ON THE SAW UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND INSTALLATION
STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
INSTALLING THE TABLE EXTENSION WING
1. Remove the four bolts with lock washers and flat
washers already mounted on the main table.
3. Re-install the bolts with lock washers and flat wash-
ers under the extension table hand tight for now.
4. Place a square or a straight edge across the ex-
tension table and the main table to align the ta-
ble extension, then tighten the 4 bolts with a 17 mm
wrench.
2. With the help of an assistant, align the extension ta-
ble mounting holes with the corresponding holes in
the main table.
5. Install the hose clamp onto the end of the hose in-
side the cabinet.
6. Slide the hose onto the outlet, then tighten the hose
clamp with a Phillips screwdriver.
To Next Page
Loading...
