BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS UN-
PLUGGED. DO NOT PLUG IN OR TURN ON THE SAW UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND INSTALLATION
STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
4. While holding the table leveled with the sliding table,
turn the bolts A so that the head touches the sliding
table edge, then lock the bolts in position by tighten-
ing the jam nuts B using a 14 mm wrench. Once the
bolts are adjusted, tighten the lock lever C.
Note: To move the auxiliary table right or left, loosen the
lock lever C.
3. Place a straight edge across the sliding and auxilia-
ry tables.
A B
C
TO REDUCE THE RISK OF SHOCK OR FIRE DO NOT OPERATE THE UNIT WITH A DAMAGED POWER CORD OR PLUG.
REPLACE A DAMAGED CORD OR PLUG IMMEDIATELY. TO AVOID UNINTENTIONAL START-UP, MAKE SURE THAT BOTH OF
THE POWER SWITCHES ARE IN THE OFF POSITION BEFORE CONNECTING TO A POWER SOURCE.
BASIC ADJUSTMENTS & CONTROLS
Once the assembly steps have been completed, plug
the power cord into an appropriate outlet.
Refer back to the section entitled “Electrical Require-
ments” and make sure all requirements and grounding
instructions are followed.
When cutting operations have been completed un-
plug the saw from the power source.
CONNECTING TO A POWER SOURCE
SWITCH OFF
2. Slide the table onto the front rail of the sliding table.1. Install the auxiliary table lock lever.
INSTALLING THE SMALL AUXILIARY TABLE
29
To Next Page
Loading...
