The pre-incisive scoring blade can be raised or lowered independent of the main blade and is driven by a sepa-
rate motor. For panel processing and furniture making the use of a scoring blade greatly improves the quality of
cuts on composite panels to produce professional quality results in industrial shop settings.
Equipped with a quick-release combination riving style splitter and see-through blade cover attachment con-
trolled with a simple lock-lever, the blade cover on this saw can also be connected directly to a dust collector to
remove dust at the source right above the blade to help reduce airborne dust in the shop.
An optional outrigger attachment (model 50-565A) for the built-in sliding table is also available to extend the saw’s
crosscutting capacity for safe easy processing of full-sized 4’ x 8’ panels.
Note: This saw model is available in several different electrical motor voltages and configurations, from single to three-
phase.
For shops with frequent visitors or multiple operators, it is advisable to establish a safety zone around shop machin-
ery. A clearly defined “no-go” zone on the floor around each machine can help avoid accidents that could cause
injury to either the operator or the shop visitor.
It is advisable to take a few moments to either paint (using non-slip paint) or using tape, define on the floor the
limits or perimeter of each machines safety zone.
Take steps to ensure that all operators and shop visitors are aware that these areas are off limits whenever a ma-
chine is running for everyone but the individual operating the unit.
INSTALLATION
This machine should be installed and operated only on a solid, flat and stable floor that is able to support the
weight of the sander (656 lbs - 298 kg) and the operator. Using the dimensions shown as a guideline, plan for
placement within your shop that will allow the operator to work unencumbered and unobstructed by foot traffic
(either passing shop visitors or other shop workers) or other tools or machinery.
BASIC FUNCTIONS
PLACEMENT WITHIN THE SHOP
ESTABLISHING A SAFETY ZONE
8
THIS MODEL 50-560A 10” SCORING SAW IS HEAVY. DO NOT OVER-EXERT. A HOIST OR FORKLIFT WITH STRAPS SHOULD
BE USED TO LIFT THIS MACHINE. TO LIMIT THE RISK OF SERIOUS INJURY OR DAMAGE TO THE MACHINE, ANY EQUIP-
MENT USED TO LIFT THIS MACHINE SHOULD HAVE A RATED CAPACITY IN EXCESS OF 656 LBS (298 KG).
To Next Page
Loading...
