BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS UN-
PLUGGED. DO NOT PLUG IN OR TURN ON THE SAW UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND INSTALLATION
STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
INSTALLING THE MITER GAUGE STORAGE BRACKET
1. Remove the two screws in the front of the cabinet
using a Phillips screwdriver, then secure the storage
bracket to the cabinet with the screws
2. Store the miter gauge on its storage bracket when
not in use.
4. Lock the fence face in place by tightening the two
lock levers A.
Note: To lock the fence assembly in position, tighten the
levers B & C.
5. Re-install the end cap on the fence face.
INSTALLING THE CROSS CUT FENCE
3. Slide the fence face onto the fence body as shown.
A
B
C
28
To Next Page
Loading...
