12
INSTALLING THE SLIDING TABLE (CONTINUED)
9. Place a square or a straight edge across the table and
the sliding table to ensure that they are leveled. If lev-
eled, tighten the bolts you have just hand tightened
with a 17 mm wrench and re-install the front plate. If the
tables are not leveled, go to the next step.
Note: To secure the sliding table, slide the table to access
the bolts from inside the cabinet.
10. Turn the bolts under the sliding table so that the main
table and the sliding table are leveled. Tighten the
bolts hand tightened at the step 8 with a 17 mm
wrench.
Note: To secure the sliding table, slide the table to access
the bolts from inside the cabinet.
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS UN-
PLUGGED. DO NOT PLUG IN OR TURN ON THE SAW UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND INSTALLATION
STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
3. Re-install bolts B and tighten them with a 10 mm
wrench.
4. Tighten carriage bolts A with a 10 mm wrench.
B
A
INSTALLING THE MAGNETIC SWITCH
1. Loosen the 2 carriage bolts A and remove the other
2 carriage bolts B.
2. Slide the switch mounting bracket onto the front
bolts A
and hand tighten them from inside the cab-
inet.
A
B
B
A
To Next Page
Loading...
