BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS UN-
PLUGGED. DO NOT PLUG IN OR TURN ON THE SAW UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND INSTALLATION
STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
INSTALLING AND CONNECTING THE BLADE COVER (CONTINUED)
7. Slide one end of the hose onto the dust tube, then
tighten the hose clamp with a Phillips screwdriver.
8. Slide the other end of the hose onto the blade cover
outlet.
INSTALLING THE SLIDING TABLE HANDLE
1. Using a Phillips screwdriver, remove the 3 screws at
the right end of the sliding table.
2. Secure the sliding table handle using the 3 screws.
1. Insert the cross cut fence body into the sliding table
T-slot.
2. Remove the cross cut fence face end cap.
INSTALLING THE CROSS CUT FENCE
27
To Next Page
Loading...
