Keep the trunnions (both accessible by sliding the table to right or left) clean, well lubricated and free of dust or
debris. Clean and remove dust, debris, and old grease as needed. After cleaning, re-apply an all purpose grease
as needed.
RECOMMENDED OPTIONAL ACCESSORIES
item #50-565A
OUTRIGGER SLIDER
For 50-560A.
item #10-410/130
DUST HOSES
4" x 50' or 4" x 10'.
item #50-570
DADO ADAPTATOR KIT
For 50-560A.
DUST COLLECTORS
We have a wide selection of
dust collectors to suit all your
shop needs. Dust collectors
contribute to a cleaner and
more healthful workshop en-
vironment.
We offer a large variety of products to increase convenience, productivity, accuracy and safety when using your
saw. Here’s a small sampling of optional accessories available from your local General International dealer.
For more information about our products, please visit our website at www.general.ca
40
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
LUBRICATION
Note: The motor and all bearings are sealed and permanently lubricated – no further lubrication is required.
FRONT RIGHT SIDEFRONT LEFT SIDE
Keep the blade height and tilt adjustment mechanism (both accessible by the motor cover door) well lubricated
and free of dust or debris. Clean and remove dust, debris, and old grease as needed. After cleaning, re-apply an
all purpose grease as needed.
REAR LEFT SIDE REAR RIGHT SIDE
To Next Page
Loading...
