5. Loosen the blade cover lock lever and remove the
blade cover to access the set screws.
6. Unscrew screws A using a 4 mm Allen key. Then using a
3 mm Allen key, adjust set screws B or C in the required
direction to square the riving knife. Re-install the riving
knife and verify that it is now squared. Re-adjust the set
screws as needed. Retighten screws A.
3. Open the blade cover and place a square on the
table against the riving knife. If the riving knife is not
squared to the table, go to the next step.
4. Slide the table to the right and open the lower blade
guard.
Note: A safety switch shuts off the machine when the lower
blade guard is opened.
90°
32
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
2. Raise the blade by turning the blade height hand-
wheel all the way to the right.
To set the splitter/knife 90º to the table proceed as follows:
1. Position the blade at 90° by turning the tilt hand-
wheel all the way to the right.
RIVING KNIFE ADJUSTMENT (CONTINUED)
C
B
A
To Next Page
Loading...
