GV-AS200 Controller
65
2
2.4.2 Operation
GV-ASKeypad allows you to configure basic settings and view system information of GV-
AS200.
2.4.2.A Setting Parameters
To set parameters of GV-AS200:
1. Press any buttons on the keypad, select Set Parameter, and press the
button.
2. Press the default password 1234.
3. To set parameters:
• Press the Up and Down arrow buttons to change options.
• Press to start setting, or apply settings.
• Press to return to the home page.
Option Function
Set Local Time Sets the time and specify the time zone of GV-AS200.
Set AS200 ID
Sets the ID of GV-AS200
Set Work Mode Sets one authentication mode for access control. For details on
each mode (One-Way Control, Two-Way Control, Mixed Control
or One-Way Traffic), see Work Mode.
Set GV-Reader ID This option is ONLY required when GV-Reader is connected to
GV-AS200 through RS-485 connection.
Password Change Changes the password of GV-GV-ASKeypad.
Default Setting Restores GV-AS200 to factory defaults. For default vales, see 2.3.2
Restoring Factory Defaults.
To Next Page
Loading...
Need help?
General
