What to do if my Gerber EDGE 2 cut lines don't match the print job?
If the cut lines of your print job do not align with the printed image, verify that proper cut registration was established when aligning the knife with the registration mark.
What to do if my Gerber Printer has poor print registration?
To improve print registration, avoid butting colors directly against each other in your design. Instead, use traps, bleeds, chokes, and spreads as you prepare the job in your design program.
What to do if my Gerber EDGE 2 shows 'WARMUP ERROR'?
If the warmup process takes longer than 5 minutes, a non-recoverable error message appears. Press the Reset key and call the Gerber Field Service Department.
What to do if my Gerber EDGE 2 Printer has light spots in a repeating pattern?
Clean the platen. If the problem persists, please call your distributor or the Gerber Field Service Department.
General| Print Technology | Thermal Transfer |
|---|---|
| Resolution | 300 dpi |
| Power Requirements | 100-240V AC, 50/60Hz |
| Connectivity | Serial |
| Media Types | Vinyl, Polyester |
| Min Sheet Size | N/A (Continuous roll media) |
| Max Material Thickness | 0.010 inches |
| Software Compatibility | Gerber Software |
Details key features and capabilities of the GERBER EDGE 2 printer.
Outlines the organization of the manual and the topics covered in each chapter.
Provides contact information for support and troubleshooting assistance from Gerber.
Defines symbols and text styles used throughout the manual for clarity.
Highlights critical safety warnings and guidelines to prevent injury and equipment damage.
Instructions for safely unpacking and repacking the EDGE 2 printer for transport.
Lists the items included in the EDGE 2 printer's shipping boxes.
Specifies the necessary computer system configurations for the EDGE 2 to function correctly.
Step-by-step guide on establishing a physical connection between the EDGE 2 and the computer.
Instructions for integrating the EDGE 2 printer within the GRAPHIX ADVANTAGE software.
Explains the recommended materials and their importance for optimal print quality.
Guidance on proper storage and cleaning of vinyl materials to maintain print quality.
Instructions on how to properly set up and use the tensioner assembly for material feeding.
Detailed steps for correctly loading vinyl material into the EDGE 2 printer.
Comprehensive guide on how to install and secure a foil cartridge into the EDGE 2.
Explains the overall workflow from job creation to final print output, including cutting.
Factors and settings crucial for creating successful print jobs on the EDGE 2.
Detailed explanation of the keypad, display, and function of each key on the EDGE 2 control panel.
Step-by-step instructions on how to send a job and initiate the printing process on the EDGE 2.
Procedures for pausing, resuming, or canceling a print job during operation.
Steps to take when the foil runs out mid-job, including replacement and continuation.
Guidance on aligning and cutting printed jobs using a plotter with registration marks.
How to access and navigate the EDGE 2's setup menu for configuration.
Instructions for running built-in test patterns to diagnose printing issues.
How to adjust specific settings like test patterns, overlap, and checksum for optimal performance.
Steps to reset the EDGE 2 to its original factory default configurations.
Method for matching print jobs created on older EDGE models using spool files.
Lists common error messages and provides required actions to resolve them.
Solutions for common printing issues like registration errors, lines, and imperfections.
Guidance on troubleshooting issues that may occur during the EDGE 2's startup sequence.
Procedures for cleaning critical components to maintain print quality.
Instructions for cleaning moving parts and squeegees to ensure smooth operation.
Steps for cleaning the platen area to remove debris and maintain print surface integrity.
Guidance on locating and replacing the fuses in the EDGE 2 printer.
To Next Page
