7.5 Setup WireGuard Server on GL.iNet router
WireGuard® is an extremely simple yet fast and modern VPN that
utilizes state-of-the-art cryptography. It aims to be faster, simpler, leaner,
and more useful than IPSec, while avoiding the massive headache. It
intends to be considerably more performant than OpenVPN.
GL.iNet routers have pre-installed WireGuard Server and Client.
Make sure Internet Service Provider assigns you a
public IP address¶
Please check if you Internet Service Provider assigns you a public IP
address here.
If no, you can't connect to the WireGaurd Server.
An alternative method is to use a reverse proxy solution, we
suggest AstroRelay.
Network Topology
• If GL.iNet router is the main router in your network, this is simple,
please move to the next step.
• If you already have a main router, then the GL.iNet router is
under the main router, you may need to setup a port forwarding
on the main router.
• If you already have a main router, the GL.iNet router is several
levels below it and you need to set up port forward on each level.
Setup WireGuard Server
Access to web Admin Panel, on the left side -> VPN -> WireGuard Server.
1. Click Generate Configuration (Only the first time).
To Next Page
Loading...
Need help?
General
