EasyManua.ls Logo

Glow-worm Ultracom2 sxi - Mounting; Fixing to the Wall

Glow-worm Ultracom2 sxi
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0020112600_02-10/12-Glow-worm
- 12 -
INSTALLATION
 
• Makesurethattheequipmentusedforimplementingthe
installationiscompatiblewiththatoftheappliance.
• Determinetheassemblylocation.Seethe"Appliance
location"chapter.
735
709
63
156
160
160
Ø105*
Ø125*
Ø130**
Ø150**
=246=
170
65
65
58
58
 
 
• Takethewalltemplateandplaceinthedesiredposition
onthewall,givingdueconsiderationtotherequiredboiler
clearances,seechapter"Appliancelocation►Clearances",
andtheueyouaretting.
 
130
90°
6
5
4
1
2
3

 
 
 
 
 
 
Flue hole cutting
• Markthepositionoftheuecentre.
• Removethewalltemplate,thendrilltheuehole.
i
The ue is designed with an internal fall of 44mm/
metre (2.5º), therefore the hole can be drilled
horizontally.
• Usea105mmdiametercoredrillforexternalaccessue
installation(60/100ue)(80/125ue►Ø130mm).
• Usea125mmdiametercoredrillforinternalaccessonlyue
installation(60/100ue)(80/125ue►Ø150mm).
i
If ue extension pipes are to be used then a core
drill size of 125mm is required. This will allow the
extension pieces to slope at 44mm/metre (2.5º)
towards the boiler.
• Ifttingasideue,extendtheuecentrelineintothecorner
then130mmalongtheadjacentwall.
• Ifttinganextendedsideue,determinetheueholecentre
byextendingthedashedinclinedlineonthetemplatetothe
sidewall.Thisdashedlineisdrawnat44mm/metre(2.5º)
risefromtheboiler.Wherethislinereachesthesidewall,a
horizontallineshouldbemarked.Theverticalcentrelineof
theueshouldthenbemarkedat130mmfromthebackwall.
Toallowfortheuepassingthroughthewallatthisangle
a125mmholeshouldbedrilledirrespectiveofinternalor
externalinstallation.
Hanging bracket xing
Duetothevariedsiteconditions,xingsarenotsuppliedand
advisethattheinstallershouldsupplythosewhicharesuitable.
• Drilltheholesforthexingscrewsinaccordancewiththe
walltemplate.
• Fixthehangingbracketonthewall.

Table of Contents

Other manuals for Glow-worm Ultracom2 sxi

Related product manuals