0020112600_02-10/12-Glow-worm
- 13 -
INSTALLATION
a
With regards to the Manual Handling Operations,
1992 Regulations, the following lift operation
exceeds the recommended weight for a one
person lift, refer to chapter "Manual Handling".
2
1
• Liftingtheboilerintoposition,leanthetopoftheboiler
slightlytothewallandpositionjustabovethehanging
bracket.
• Lowertheboilerslowlyandengageontothehangingbracket
Thewholeofthegasinstallation,includingthemeter,should
beinspected,testedfortightnessandpurgedinaccordance
withthecurrentissueofBS6891andinIEthecurrenteditionof
I.S.813“DomesticGasInstallations”.
i
The appliance may contain a small amount of water,
place a water container beneath the boiler connections.
• Takecaretocleanthepipesbeforeassemblyremovingany
debrisorburrs.Greaseandoilsmayneedtoberemoved
theyarenotpossibletoremovebycleansingandushing.
Foreignbodiesinthesystemmayentertheapplianceand
interruptitsoperation.
• Donotuseanysolventproducts,duetotheriskofdamaging
thecircuit.
a
Do not perform any 'hot work' directly under
the appliance, this may cause damage to the
appliance base. Heat may also damage the
isolation valves.
Always pre-solder pipes before tting them to
the boiler.
• Onlyuseoriginalsealssuppliedwiththeappliance.
• Checkthattherearenoleaks.Repairifnecessary.
1
2
3
4
5
4
• UseonlytheoriginalgasserviceisolationvalvetypeGER/1
DN15,CE-0085CL0082
• Useonlytheolivewhichisdeliveredwiththegasisolation
valve
• Useonlyoriginalsealingwashers
• Removetheprotectivecapsfromtheboilerconnections.
• Flushoutthedomestichotwaterandtheheatingsystems.