Glow-worm Ultracom2 sxi - Pcb; 20 Spare Parts

0020112600_02-10/12-Glow-worm
- 49 -
MAINTENANCE
 
b
When replacing the board refer to instructions
supplied with the spare part.
 
A
B
B
C
1
2
1
3
4

 
 
 
 
• Removethe24Vand230Vconnections.
• Removetherearpanel(2).
• EasebackthetwoPCBretainingclips(3)andwithdrawthe
PCBfromtheretaininglugs.
• RemovetheelectricalconnectionstothePCB(appliance
interfacecable).
• Whenrettingtherearpanel,ensuretheleadsarenot
trapped.
 
• Foraccess,refertochapter"MainPCB".
• ThefuseislocatedattoprighthandsideofthePCB,see
chapter"ElectricalconnectionWiringdiagram".
 
A
C
B
B
1
2
3
4
5

 
 
 
 
 
• Removetheuserinterface(1)easingbackthetworetaining
slots(2).
• EasebackthetwoPCBretainingclips(4)andwithdrawthe
PCBfromtheretaininglugs.
• RemovetheelectricalconnectionstothePCB.
• Whenrettingtheuserinterface,ensuretheleadsarenot
trapped.
 
e
The main supply cable must be replaced by a
qualied and competent electrician.
• Ifthemainsupplycableisdamaged,replaceitreferingtothe
chapter"Electricalconnection".
 
Inordertoguaranteethesafeandprolongedlifeoftheproduct,
manufacturersgenuinesparepartsmustbeused.
i
This appliance displays a CE Mark of conformity.
Only use the manufacturer’s genuine, new spare
parts.
• Ensurethatsparepartsarecorrectlymountedintheright
positionanddirection.Afterttinganysparepartorservicing,
theappliancemustbetestedforitssafeoperation.