EasyManua.ls Logo

Glow-worm Ultracom2 sxi - Servicing; Silencer; Service Interval Record

Glow-worm Ultracom2 sxi
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0020112600_02-10/12-Glow-worm
- 39 -
MAINTENANCE
Ifafterservicingandadjustmentoftheappliancethe
combustionvaluesarestillunacceptableandafterfurther
remedialworkhasbeencarriedout,theappliancemustbe
disconnecteduntiltheCO/CO2ratioisacceptable.
• AdvicecanbesoughtfromtheGlow-wormTechnical
Helpline.
 
i
If the annual check of combustion CO2, CO/CO2 ratio
checks did not require adjustment and the inspections
described in "Preliminaries" were satisfactory then it
will not be necessary to complete a full service.
Allroutineservicingrequirementscanbeachievedbythe
removalofthefrontpanel.
• Positionthecontrolboxintotheserviceposition.
• Beforecommencingwithaserviceorreplacementofparts,
isolatetheboilerfromtheelectricalandgassupplies.
 
• Refertotheserviceintervalrecordlocatedontheinside
backpagesofthisdocument.
 
12sxi / 18sxi
A
B
C
3
2
1

 
 
 
• Removethesilencerretainingscrews(1)andremovethe
silencer(3).
• Cleantheinteriorofthesilencerwithadryclothifnecessary,
takingcarenottodamagetheinternalfoam.
• Repeattheoperationinreverseordertoreplacethesilencer.
30sxi
A
1
2
3

 
 
 
• Unclipandremovethesilencer(3).
• Cleantheinteriorofthesilencerwithadryclothifnecessary,
takingcarenottodamagetheinternalfoam.
• Repeattheoperationinreverseordertoreplacethesilencer.

Table of Contents

Other manuals for Glow-worm Ultracom2 sxi

Related product manuals