GMC 1998 Yukon - Resuming a Set Speed

1. Move the cruise
control switch
to
ON.
4. Take your foot off the accelerator pedal.
Resuming a Set Speed
2. Get up to the speed you want.
Suppose you set your cruise control at
a desired speed
and then you apply the brake. This, of course, shuts off
the cruise control.
But you don’t need to reset it.
3. Push in the SET
button at the end of
the lever and
release
it.
Once you’re going about
25 mph (40 km/h) or more,
you can move the cruise
control switch from
ON to
R/A (Resume/Accelerate)
for about half a second.
You’ll
go right back up to your chosen speed and
stay there.
Remember,
if you hold the switch at R/A longer than
half
a second, the vehicle will keep going faster until
you release the switch or apply the brake. So unless you
want
to go faster, don’t hold the switch at R/A.
2-38