GMC 1998 Yukon - Front Parking;Turn Signal Lamps with Composite Headlamps

Front Parking/Turn Signal Lamps with
Composite Headlamps
1.
Remove the four screws
and take out
the
parkingkurn signal
lamp assembly.
2. Squeeze the tab on the side of the lamp socket while
turning the socket to
the left.
3. Pull the socket out of the
lamp assembly.
4. Push in gently on the bulb, turn it to the left and
remove
it from the socket.
5. Put the new bulb into the socket, gently press in on
the bulb and turn it to the right until it is tight.
6. Put the socket back into the lamp assembly and turn
it to the right until it locks.
7. Put the parking/turn signal lamp assembly back into
the vehicle and tighten the four screws.
6-40