Audio
Systems
AM-FM
Stereo
Your Delco@ Electronics audio system
has
been
designed to operate easily and give years
of
listening
pleasure. You
will
get the most enjoyment out of
it
if
you acquaint yourself
with
it
first. Find
out
what your
Delco Electronics system can do and how to operate all
its controls, to be sure you’re getting the most out of the
advanced engineering that went into
it.
Setting the Clock
for
Systems without
Automatic Tone Control
Press SET. Within five seconds, press and hold the
SEEK right arrow until the correct minute appears on
the display. Press and hold the
SEEK
left arrow until the
correct hour appears on the display.
Setting the Clock for Systems with
Automatic Tone Control
Press
and
hold HR until
the
correct hour appears on the
display. Press and hold MN
until
the correct minute
appears on the display.
To
display the clock
with
the
ignition off, press RECALL
or
HR/MN and the time
will
be displayed
for
a
few seconds. There is
an
initial
two-second delay before the clock goes into the
time-set mode.
Playing
the
Radio
VOLUME:
This knob turns the system on and
off
and
controls the volume.
To
increase volume and turn the
radio on, turn the knob to the right. Turn it
to
the left to
decrease volume.
RECALL:
Display the time with the ignition
off
by
pressing the recall knob. When the radio is playing,
press this knob to recall the station frequency.
Finding
a
Station
AM-FM:
Press the lower knob to switch between AM
and
FM.
The display shows your selection.
3-10
To Next Page
Loading...
