In
addition to the four stations already set, up
to
three
more stations may be preset on each band by pressing
two adjoining buttons
at
the same time. Just:
1.
Tune
in
the desired station.
2.
Press SET.
(SET
will appear on the display.)
3.
Press two adjoining buttons
at
the same
time,
within
five seconds. Whenever you press the same two
buttons, the station you set
will
return.
4.
Repeat the steps for each pair
of
pushbuttons.
PSCAN:
Press both SEEK buttons to scan through each
of your preset stations. The system will scan through
and play each preset station stored on your pushbuttons
for
a
few seconds. Press either
SEEK
button or
RECALL
to
stop scanning through the preset stations.
Setting the Tone
BASS:
Slide this lever up or down to increase or
decrease bass.
TREB: Slide this lever
up
or down
to
increase or
decrease treble.
If
a station is weak or noisy, you may
want to decrease
the
treble.
Adjusting the Speakers
BAL:
Turn the control behind the upper
knob
to
move
the sound
to
the left
or
right speakers. The middle
position balances the sound between the speakers.
FADE:
Turn the control behind the lower
knob
to
move
the sound to the front or rear speakers. The middle
position balances the sound between the speakers.
Playing a Cassette Tape
Your tape player is
built
to work best
with
tapes that are
30
to
45
minutes long on each side. Tapes longer than
that are
so
thin they may not work well
in
this player.
Once the tape
is
playing, use the knobs for VOLUME,
BAL
FADE,
BASS
and TREB just as you do for
the radio.
REV Press the SEEK left arrow to reverse
the
cassette tape. Press the
SEEK
right arrow
to
stop
reversing the tape.
FWD:
Press the SEEK right arrow to advance the
cassette tape. Press the
SEEK
left arrow to stop
forwarding the tape.
RECALL:
Press this knob to switch tape sides.
EJECT
Press this button
to
remove the tape or stop
the.
tape and play the radio.
3-13
To Next Page
Loading...
