GMC 1998 Yukon - Folding the Rear Seat (4-Door Utility Model)

While the seat is in the folded position, hang the latch
plate end of the outer passenger position safety belts on
the hooks at the top of each retractor cover, out of
the way.
To return
the seat to the passenger position, just lift up
on the seatback and push it rearward until it latches.
After returning the seat
to the passenger position, pull
forward on the seatback to make sure
it is locked into
place. Also, return the safety belts and head restraints to
their original positions,
so they will be available for rear
seat passengers to use.
Folding the Rear Seat (4-Door Utility Model)
If your vehicle has a 60/40 rear seat, either side may be
folded down to give you more cargo space.
Before folding, place the latch portion of
the center
safety belt
in the center armest. That way, the center
safety belt will be out
of the way when the seat is folded
and
also will be easily available for passengers to use
when the seat is returned to the passenger position. Also,
make sure that nothing
is under or in front of the seat.
When the seat is folded,
it will lay flat on the floor.
When folding the seat, first
remove the head restraints.
Push the release buttons at
the bottom of each head
restraint height adjust
post and slide the head
restraint out
of the
height-adjust tubes.
Set the head restraints aside for now. You will stow them
in their proper position after you are done folding the seat.
1-10