To fold the seat, pull up on
Then, pull the seat cushion up and fold it forward.
After folding the seat cushion
fully
forward, pull
the
seatback forward and fold the seatback down
until
it
is flat.
Then, stow the head
restraints by sliding them
into the rear of the seatback.
Make sure the posts
go
in
all the way.
To
return the seat to the passenger position, first remove
the head restraints by sliding them out of the seat
cushion. Lift the seatback up and push rearward all the
way. Then, lower the seat cushion
until
it
latches
..
In
position.
After returning the seat to the passenger position, return
the head restraints
to
the top
of
the seatback. Pull
forward
on
the seatback and up on the seat cushion to
make sure that the seat
is
securely in place.
If
the latch plate portion of the center safety belt was put
in
the
center armrest when
the
seat was folded, take the
latch plate portion out and place
it
on the seat. That way,
the center position safety belt will be available for the
center rear seat passenger to use.
1-11
To Next Page
Loading...
