To program
a
garage door opener with the rolling code
feature, do the following:
1.
Program your hand-held transmitter to the universal
transmitter
by
following the steps provided under
“Programming the Transmittel“ earlier
in
this section.
2.
Remove the cover panel from the garage door opener
receiver.
It
is located near the garage door opener motor.
3.
Locate the training button on the garage door opener
receiver. The exact location and color
will
vary
among brands.
4.
Press the training button on the garage door opener
receiver for one to two seconds.
6.
Release the button, then press
it
again to confirm that it
was progmmmed to the garage door opener receiver.
You
may
now
use either the universal transmitter or the
hand-held transmitter to open your garage door. If
you
still have difficulty
in
programming and require
assistance, please call 1-800-355-35
15.
Accessories
Accessories for the universal transmitter are available
from the manufacturer of the unit. If
you
would like
additional information, please call 1-800-355-35 15.
5.
Return to your vehicle and press the programmed
button
on
the universal transmitter until the red light
flashes rapidly (about two seconds).
2-67
To Next Page
Loading...
