PUSHBUTTONS: The six numbered pushbuttons let
you return to
your
favorite stations. You can set up to
18
stations (six AM. six
FM
1
and six
FM2).
Just:
1
.
Turn the radio
on.
2.
Press AM-FM to selecl the band.
3.
Tune
in
the desired station.
4.
Press AUTO TONE to select
the
setting you prefer.
5.
Press and hold one of the six pushbuttons. The sound
will
mute. When
it
re.turns, release the button.
Whenever you press that numbered button, the
station you set
will
return and the tone you selected
will
be automatically selected for that button.
6.
Repeat the steps for each pushbutton.
P.SCAN:
The preset scan button lets you scan throilgh
your favorite stations stored on your pushbuttons. Select
either the
AM,
FMI
or
FM2
mode and then press
P.SCAN.
It
will
scan through each station stored on your
pushbuttons and stop for
a
few seconds before continuing
to
scan
through all
of
the pushbuttons. Press P.SCAN
again or one of the pushbuttons to stop scanning to listen
t.o
it
specific stored station. PSCAN will light
up
on the
display while
in
this
mode.
If
one of the stations stored on
a
pushbutton is too weak
for
the location you are
in.
the
radio display
will
show the channel number
(PI
-P6)
for
several
seconds
before advancing to the next preset station.
Setting the Tone
BASS:
Press lightly
on
this knob
to
release
it
from
its stored position.
Turn
the knob to the right
to
increase
bass and to the
left
to decrease bass.
When
the BASS
control is rotated, the AUTO TONE display
will
go blank.
TREB: Press lightly on this knob
to
release
it
from its
stored position. Turn the knob
to
the right
to
increase
treble and to the
left
to decrease treble. When the TREB
control is rotated, the AUTO TONE display
will
go
blank.
If
a
station
is
weak or noisy, you may want
to
decrease the treble.
Push these knobs back into their stored positions when
you’re not using them.
AUTO
TONE:
Press this button to select among the six
preset eqwdization settings and tailor the sound to the
music or voice being heard. Each time you press the
button, the selection will switch to one of the preset
settings
of
CLASSIC, NEWS, ROCK, POP, CnV
(Country/Western) or JAZZ.
To
return to the manual
mode, press and release this button
until
the AUTO
TONE
display goes blank. This
will
return the tone
ad~justment to the BASS and TREB controls.
If
a
BASS
or TREB control is rotated, the AUTO
TONE
display
will
go
blank.
To Next Page
Loading...
