GME CP30 - Page 82

CP30 INSTRUCTION MANUAL
78
Emergency
NOTE: This feature is enabled via the programmer, contact your Authorised GME
Commercial dealer.
Press the programmed Emergency button, (Top-Red Button) to immediately send
a designated Emergency SelCall transmission to other radios in your group. During
this time your radio will sound an alarm and display EMERGENCY. The emergency
SelCall transmissions will continue until cancelled by the Exit Emergency button.
Other radios in your group that receive the Emergency signal will also sound an
alarm and ALARM will be displayed on the LCD.
Exit Emergency
Press the programmed Exit Emergency button to cancel the Emergency. The
Emergency SelCall transmissions will cease and the alarm will stop.
Keylock Toggle
Press the programmed Keylock key to toggle the Keylock function ON or OFF.
LOCKED or UNLOCK will be displayed briey to conrm the status of the keylock
function.
Monitor Toggle
Press the programmed Monitor Toggle key to toggle the Monitor function ON
or OFF.
Monitor Menu
1. Press the programmed Monitor Menu key to access the Monitor menu.
2. Rotate the Channel Selector knob or press the keys to select ON or
OFF.
3. Press the
MENU
F
key to exit or wait a few seconds for the menu to time-out.
Power Saving Cycle
Press the programmed Power Saving key to cycle OFF, LO or HI.
• Select OFF to switch the Power Save function O. The radio will
remain active at all times and will draw the most amount of power
from the battery.
• Select LO to enable the Power Save function at a conservative setting.
The radio will sleep during periods of inactivity but will respond
quickly to incoming signals.
• Select HI to enable the Power Save function at a more aggressive
setting. The radio will conserve the most amount of power but may
not be as responsive to incoming signals.