Godex GS220 - GS1 Databar; GS1 Databar Configuration

4–1
GS1 Databar
GoDEX’s GS220 scanners with software #14810 and higher can be
configured to scan GS1 Databar type bar codes.
³100011
Double Border Required – Due to the large
spaces commonly found in GS1 Databar
symbologies, GoDEX recommends double
border requirements be enabled when scanning
GS1 Databar code type symbologies.
³100413
Enable GS1 Databar 14
³100403
* Disable GS1 Databar 14
³114900
* Transmit GS1 Databar 14 Check Digit
³114910
Do Not Transmit GS1 Databar 14 Check Digit
³114901
* Transmit GS1 Databar 14 Application ID
–
Application Identifier “01” is transmitted
by default.
³114911
Do Not Transmit GS1 Databar 14
Application ID
³114902
* Transmit GS1 Databar 14 Symbology ID –
Symbology Identifier “]e0” is transmitted
by default.
³114912
Do Not Transmit GS1 Databar 14 Symbology
4