Google Pixel 6 Pro - Apply Primer on Display; Aligning Display Module

Google 2021 | Confidential and Proprietary | Do not distribute 49
Display
14. Apply primer on display
15. Aligning display module
●
Apply 3M UPUV Primer around the edges of the Display module
using a Dust-free Dust-free Cotton swabs. Use an Ionizing air fan
to blow over the device to prepare the Primer for the adhesive.
●
Remove the copper protective film from the blue liner first.
Part: G949-00219-01 (Display module), G806-06032-01 (copper protective film)
●
Use the Universal adsorption-bulb to prop up the Display
module.
When apply UPUV primer to the CG module, pay attention to avoid touching
copper and sponge areas (as shown above red figure). Once Primer has
been applied, complete assembly in 25 mins.
Bottom spe
aker
MicLogic bo
ard
BatteryFront ca
mera
Top
Speaker
Rear ca
mera
Upper mid-f
rame
mmWaveMid-frameGraphic sh
eet
Display