Google Pixel 6 Pro - Connect Display Module; Check Display

Google 2021 | Confidential and Proprietary | Do not distribute 50
Display
16. Connect display module
17. Check display
●
Connect the Display flex to the Logic board, applying
pressure evenly across the connector to ensure it is fully
engaged.
●
Remove the Universal adsorption-bulb and display
protective film.
●
Power on to check if the device is working properly, Power off
device after checking.
Do not touch the TP until it turns to shipping mode since touch panel
self calibration is in progress. Follow the instruction below:
TP Calibration Note
Bottom spe
aker
MicLogic bo
ard
BatteryFront ca
mera
Top
Speaker
Rear ca
mera
Upper mid-f
rame
mmWaveMid-frameGraphic sh
eet
Display