GPD Global CF-9 User Manual

Documentation Package
for CF-9 Taped Radial Component Lead Former
PN 901-1-01
CONTENTS of CF-9 Documentation Package
Operating Guide
In addition to installation, set up, and operating
procedures, this guide includes electrical schematics and
maintenance, troubleshooting, spare parts, and
specifications details.
Bills of Material
Includes an illustrated bill of material with associated
part numbers for each CF-9 subassembly.
Die Catalog
Catalog of dies precisely manufactured by GPD Global®
to accurately form Radial components into a wide
variety of component shapes.
Set Up Form
Fill out this Set Up form and then use it as a guide for
consistent results for each component part number.
611 Hollingsworth Street
Grand Junction, CO, USA 81505
tel: +1.970.245-0408
fax: +1.970.245-9674
request@gpd-global.com
www.gpd-global.com

GPD Global CF-9 Specifications

General

Category	Industrial Equipment
Model	CF-9
Type	Dispensing System
Output	Dispensed fluid
Power Supply	220V AC, 50/60 Hz
Fluid Compatibility	Wide range of fluids, including adhesives, solder pastes, and lubricants
Vision System	Integrated high-resolution camera for automated alignment and inspection
Programming	User-friendly software interface with graphical programming capabilities
Flow Range	0.001 - 10 ml/min (depending on dispensing head)
Accuracy	+/- 1% (depending on fluid and dispensing parameters)
Pressure Rating	0 - 7 bar
Temperature Range	15 - 35°C
Material	Aluminum frame with stainless steel components

Summary

Warranty

Safety Instructions

Safety Notice Definitions

Explains DANGER, WARNING, CAUTION, IMPORTANT, and NOTE symbols used in the manual.

Function

Machine Functions

Machine Part Identification

Control Panel

Panel Controls and Indicators

Die Block Assembly

Installation

Operating Instructions

Setup Steps

Step-by-step guide for preparing the machine for operation.

Process Components

Instructions for running the machine to form components.

Power Off Procedure

Steps for safely shutting down the machine.

Die Installation

Ejector Bracket Installation

Station Adjustment

Component Alignment

Load Components

Preventive Maintenance

Maintenance Schedule

Outlines daily, monthly, and yearly maintenance tasks for the machine.

Troubleshooting

Slide Travel Adjustment

Procedure for adjusting the slide travel for proper machine operation.

Slide Clearance Adjustment

Steps for setting and verifying slide clearance.

Specifications

Power Requirements

Taping Specifications