GPD Global CF-9 - Page 29

CF-9 User's Guide
22 GPD Global 09/30/92
Preventive Maintenance Schedule
(continued)
Interval Location Action
Monthly Die Block Assembly Clean die block adjusting bolt (Figure 18, Item 1) with
solvent and apply a small amount of oil to its thread
near machine upright plate.
Inside Cabinet Inspect component drive belt for proper tension.
Spray molly grease on gears. Wipe off excess oil.
Lightly grease cam lobes and cam follower rollers.
Wipe off excess grease.
Check motor brushes and motor drive belt. Replace if
they appear worn or frayed.
CAUTION: DO NOT
attempt to remove or replace a
drive belt without first loosening the motor mount
screws.
Yearly Safety Shield Apply a drop of light machine oil on each safety shield
hinge. Wipe off excess oil.