LIMITFEED
Description
When feeding labels, if the gap sensor is not set to a suitable sensitivity, the
printer will not be able to locate the correct position of the gap. This command
is used stop label feeding and make the red LED flash if the printer does not
locate gap after feeding the length of one label plus one preset value.
Syntax
LIMITFEED n (inch, the English system)
LIMITFEED n mm (mm, the metric system)
Parameter Description
n inch or mm
Remark
The setting will remain resident in memory.
The default value is 10 inches when printer initializes.
For metric system, there must be a space between parameter n and mm.
SELFTEST
Description
At this command, the printer will print out the printer information on the label.
Syntax
SELFTEST
Example
SELFTEST
To Next Page
Loading...
