4. BOX
Description
This command is used to draw rectangles on the label.
Syntax
BOX X_start, Y_start, X_end, Y_end, line thickness
Parameter Description
X_start Specify x-coordinate of upper left corner in dot
Y_start Specify y-coordinate of upper left corner in dot
X_end Specify x-coordinate of lower right corner in dot
Y_end Specify y-coordinate of lower right corner in dot
line thickness Line thickness of the box in dot
Note: 203 DPI: 1 mm = 8 dots
300 DPI: 1 mm = 12 dots
Recommended max. thickness of box is 12mm at 3” width.
Thickness of box that is larger than 12 mm may damage the power
supply and affect the print quality.
Max. print ratio is different for each printer model. Desktop and
industrial printer print ratio is limited to 20% and 30%
respectively.
Example
SIZE 4,2.5
GAP 0,0
SPEED 6
DENSITY 8
DIRECTION 0
CLS
BOX 100,100,200,200,5
PRINT 1,1
See Also
BAR
To Next Page
Loading...
