10. TEXT
Description
This command is used to print text on label
Syntax
TEXT X, Y, ”font”, rotation, x-multiplication, y-multiplication, “content”
Parameter Description
X The x-coordinate of the text
Y The y-coordinate of the text
font Font name
1 8 x 12 fixed pitch dot font
2 12 x 20 fixed pitch dot font
3 16 x 24 fixed pitch dot font
4 24 x 32 fixed pitch dot font
5 32 x 48 dot fixed pitch font
6 14 x 19 dot fixed pitch font OCR-B
7 14 x25 dot fixed pitch font OCR-A
8 21 x 27 dot fixed pitch font OCR-B
TST24.BF2 Traditional Chinese 24 x 24 font(Big 5)
TSS24.BF2 Simplified Chinese 24 x 24 font (GB)
K Korean 24 x 24 font (KS)
Rotation The rotation angle of text
0 0 degree
90 90 degrees, in clockwise direction
180 180 degrees, in clockwise direction
270 270 degrees, in clockwise direction
X-multiplication: Horizontal multiplication, up to 10x.
Available factors: 1~10 width (point) of true type font.
1 point=1/72 inch.
Y-multiplication: Vertical multiplication, up to 10x.
Available factors: 1~10
For true type font, this parameter is used to specify
the height (point) of true type font.
1 point=1/72 inch.
Note:
1. If there is any double quote (“) within the text, please change it
to \[“].
2. If to print OD(hex), please use \[R] to print CR in the program.
3. If to print OA(hex), please use\[A] to print LF in the program.
4.Only use capital letters.
To Next Page
Loading...
