8. QRCODE
Description:
This command prints QR code.
Syntax
QRCODE x,y,ECC Level,cell width,mode,rotation,[model,mask,]"content"
Parameter Description
x The upper left corner x-coordinate of the QR code
y The upper left corner y-coordinate of the QR code
ECC level Error correction recovery level
L : 7%
M : 15%
Q : 25%
H : 30%
cell width 1~10
mode Auto / manual encode
A : Auto
M : Manual
rotation 0 : 0 degree
90 : 90 degree
180 : 180 degree
270 : 270 degree
model 1: (default), original version
2: enhanced version
(Almost smart phone is supported by this version.)
mask 0~8, default is 7
content The encodable character set is described as below,
Encodable character set:
1) Numeric data: (digits 0~9)
2) Alphanumeric data
Digits 0-9
Upper case letters A-Z
Nine other characters: space, $ % * + - . / : )
3) 8-bit byte data
JIS 8-bit character set (Latin and Kana) in accordance
with JIS X 0201
4) Kanji characters
Shift JIS values 8140HEX –9FFCHEX and E040HEX –EAA4
HEX. These are values shifted from those of JIS X 0208.
Refer to JIS X 0208 Annex 1Shift Coded Representation
for detail.
To Next Page
Loading...
