GPRINTER GP-3150TIN - Page 22

Use “!” as a starting character for the control code followed by three
control codes.
If the start subset is not set, the default starting subset is B.
 EAN128 Code 128, switching code subset A, B, C automatically
 25 Interleaved 2 of 5
 25C Interleaved 2 of 5 with check digits
 39 Auto switch full ASCII and standard code 39 for
PLUS models.
 39C Code 39 full ASCII with check digit
Code 39 standard with check digit
Auto switch full ASCII and standard code 39 for
PLUS models.
 39S Code 39 standard
 93 Code 93
 EAN 13 EAN 13
 EAN 13 + 2 EAN 13 with 2 digits add-on
 EAN 13 + 5 EAN 13 with 5 digits add-on
 EAN 8 EAN 8
 EAN 8 + 2 EAN 8 with 2 digits add-on
 EAN 8 + 5 EAN 8 with 5 digits add-on
 CODA Codabar
 POST Postnet
 UPCA UPC-A
 UPCA + 2 UPC-A with 2 digits add-on
 UPCA + 5 UPC-A with 5 digits add-on
 UPCE UPC-E
 UPCE + 2 UPC-E with 2 digits add-on
 UPCE + 5 UPC-E with 5 digits add-on
 CPOST China post code
 MSI MSI code
 MSIC
 PLESSEY PLESSEY code
 ITF 14 ITF 14 code
 EAN 14 EAN 14 code
 height bar code height expressed by dot
 human readable 0: human not readable
1: human readable
Control code
A
B
C
096
FNC3
FNC3
NONE
097
FNC2
FNC2
NONE
098
SHIFT
SHIFT
NONE
099
CODE C
CODE C
NONE
100
CODE B
FNC4
CODE B
101
FNC4
CODE A
CODE A
102
FNC1
FNC1
FNC1
103
Start (CODE A)
104
Start (CODE B)
105
Start (CODE C)