EasyManua.ls Logo

Gradient syncFURNACE mOD-200 - General and Safety Instructions; Included in Packaging

Gradient syncFURNACE mOD-200
81 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
syncFURNACE OD Instruction & Installation Manual Rev 09 Pg. 6 of 81
2. GENERAL AND SAFETY INSTRUCTIONS >
1. After receiving the product, inspect the unit for any possible physical damage that may have
occurred during transportation.
2. These instructions must be kept at installation site. Additional copies are available - on request -
from Gradient Thermal Inc.
3. Installation, Start-up & Service must be performed with due care and attention and must only be
performed by competent, qualified, licensed and trained heating contractor(s).
4. Always be safety conscious. Never risk your health or your life. Your safety and the safety of the
dwelling occupants must always take highest priority.
5. Failure to read and comply with all instructions and applicable National and local codes may result
in hazardous conditions that could result in property damage and injury to dwelling occupants
which in extreme cases may result in death.
6. Improper installation, service and/or maintenance can cause flue products to flow into living space.
Flue products contain poisonous carbon monoxide. Properly install product to minimize carbon
monoxide output and to ensure safe operation to prevent flue products from entering living space
by following the venting installation instructions in this manual and installation
instructions provided by venting material manufacturer.
7. Never operate this product without a venting system. An improper venting system can cause
carbon monoxide poisoning.
8. Information contained inside this and other related product documentation must be read and
followed. Failure to do so may result in loss of warranty coverage. Warranty will be rendered null
and void.
3. INCLUDED IN PACKAGING >
syncFURNACE OD qty 1
Document Package qty 1 replacement part no. 110184
Outdoor Sensor qty 1 replacement part no. 110182
!
DANGER
!
WARNING
Should overheating occur or the gas supply fail to shut-off, DO NOT turn off or
disconnect the electrical supply to the pump. Instead, shut-off the gas supply at a
location external to the appliance.
DO NOT use this product if any part has been under water. Immediately call a qualified
service contractor to inspect and if necessary replace any affected electrical or gas control
component(s)
!
WARNING
REFRACTORY CEMENT FIBER (RFC) > Certain components confined in the combustion
chamber may contain this potential carcinogen. Improper installation, adjustment,
alteration, service or maintenance can cause property damage, serious injury (exposure to
hazardous materials) or death. Refer to APPENDIX D for information on handling
instructions and recommended personal protective equipment.

Table of Contents

Related product manuals