Gradient syncFURNACE mOD-200 - Annual Inspection & Maintenance Record

syncFURNACE OD Instruction & Installation Manual – Rev 09 Pg. 70 of 81
APPENDIX E: ANNUAL INSPECTION & MAINTENANCE RECORD >
@ Installation Year 2 Year 3 Year 4 Year 5
Date: Date: Date: Date: Date:
1
Inspect the general condition of the
heating system & its components
2
Test functions of all the demands
wired into the product
3
Check gas system for leaks
4
Check plumbing system for leaks
5
Verify product chasis ground
through continuity check with volt
meter
6
Verify external expansion tank
diaphram pressure (If installed)
7
Check / C lean Water Filter /
Strainers
8
Clean combustion chamber
9
Check flame sensor & direct spark
electrodes for wear, correct gap
10
Verify drainage of condensation
trap system (internal & external)
11
Test no-gas / ignition safety
12
Test low-pressure alarm
13
Test water quality - verify meets
requirements of product manual
14
Test burner combustion
15
Check venting system for wear,
leaks, cracks, obstructions
A
Burner Reading CO - MAX Fire
B
Burner Reading CO2 - MAX Fire
C
Burner Reading CO - MIN Fire
D
Burner Reading CO2 - MIN Fire
E
Inlet Gas Pressure Reading
F
Water pH Readng
Inspectors Name
Contractors C ompany Name
Company Phone Number
Required Inspection-points
Inspector Signature