2-2
Setting up The Cutter Plotter
2.1 Connecting to Your Computer
The cutting plotter can be connected to a computer via the parallel (Centronics-compatible) port, serial (RS-
232C) port, or USB port. Select which port to use according to the requirements of your application software
and/or which of your computer's interface ports are available for use.
Use a Centronics-compatible parallel cable, serial cable, or USB cable in accordance with the connection
method chosen. Obtain a Graphtec approved interface cable that is compatible with the interface ports (the
interface cables are available separately).
(1) Check to confirm that the Power switch is turned off (the "O" side is down).
(2) Connect the cable between the cutting plotter and the computer. Make sure the connectors at
the cutting plotter and computer ends are correctly oriented.
To Next Page
Loading...
